Connect your NK7 to Wi-Fi to access the NK7 Web Control Center, where you can manage display, network, and other device settings directly from your browser.

No app is required. You can complete the entire Wi-Fi setup from your phone.

1. Power On Your NK7

Connect NK7 to power and turn it on.

Once it starts up, NK7 will create its own Wi-Fi network for initial setup. You’ll first connect your phone to this network, then use it to connect NK7 to your Wi-Fi.

2. Connect Your Phone to NK7

Open Wi-Fi Settings on your phone and look for the Wi-Fi network created by NK7:

AV-NK7-XXXXX

Select it to connect.

Your phone may indicate that this network has no internet access. This is normal. Your phone is connected directly to NK7 for setup and does not need internet access at this stage.

Once connected, the NK7 setup page should open automatically.

If the setup page doesn’t open automatically

Make sure your phone is still connected to the NK7 Wi-Fi network, then open a web browser.

Enter the following address directly into the browser’s address bar:

192.168.4.1

The NK7 setup page will open.

3. Connect NK7 to Wi-Fi

On the setup page, locate the Wi-Fi section.

Tap the Refresh ↻ button on the right to scan for available Wi-Fi networks.

Select your Wi-Fi network, enter the password, then tap Connect.

Once connected, NK7 will leave its setup network and join your Wi-Fi automatically.

Note: NK7 connects to 2.4 GHz Wi-Fi networks only. If your network doesn’t appear or NK7 is unable to connect, make sure 2.4 GHz Wi-Fi is enabled on your router.

4. Find Your NK7 IP Address

Once NK7 is connected to Wi-Fi, press and hold the B button to open the Settings menu.

Use the A / C buttons to navigate to Wi-Fi Status, then press B to select it.

When NK7 is successfully connected, the display will show:

Wi-Fi: Connected
IP Address: 192.168.x.x

For example:

192.168.1.123

Your NK7’s IP address is assigned by your network, so the exact address may be different on each device or network.

Use the IP address shown on your NK7 to open the Web Control Center in the next step.

5. Open the NK7 Web Control Center

Make sure your computer or phone and NK7 are connected to the same Wi-Fi network.

Open a web browser and enter the IP address shown on NK7 directly into the browser’s address bar.

For example:

192.168.1.123

The NK7 Web Control Center will open.

From here, you can manage your NK7’s display, network, and other settings directly from your browser.

For the full control experience, use a computer.
The initial Wi-Fi setup and basic controls can be accessed from your phone. For the complete Web Control Center experience, we recommend using a desktop browser.

Having Trouble Connecting?

If you’re having trouble connecting NK7 or opening the Web Control Center, try the steps below.

NK7 won’t connect to Wi-Fi

• Make sure you’re connecting to a 2.4 GHz Wi-Fi network.
• Double-check your Wi-Fi password.
• Make sure 2.4 GHz Wi-Fi is enabled on your router.
• Restart NK7 and try the Wi-Fi setup again.

Web Control Center won’t open

• Make sure Wi-Fi Status on NK7 shows Connected.
• Make sure NK7 and your computer or phone are connected to the same Wi-Fi network.
• Check Wi-Fi Status again and confirm the current IP address.
• If a previously saved IP address no longer works, use the current address shown on NK7. The IP address may change after NK7 reconnects to your network.

You’re All Set

Your NK7 is now connected to Wi-Fi and ready to use with the NK7 Web Control Center.

Whenever you want to access the Control Center again, make sure your computer and NK7 are on the same network, then enter NK7’s current IP address into your browser’s address bar.